Ballard Design: DIY Console Table

This DIY console table has been on my list of things to build for a while and I am so happy to finally be able to share it with you!

I was immediately drawn to the gorgeous legs!

Ballard Design: DIY Console Table 

Materials

– Lumber per the plans. Miter Saw Brad Nailer Kreg Pocket hole Jig Power Drill – Sander and sandpaper 1¼” pocket hole screws – 1 ¼” inch brad nail

Step 1

Using pocket holes and wood glue, put each of the 2 leg frames together. Make sure to use a scrap 1×3 as a spacer while joining the boards to help keep all the boards aligned and square. 

Step 2

There are 3 aprons on each side . The top two are 2 1/2 inches apart and I used a 1×3 scrap board for the spacing. 

Step 3

There are 5 slats total – two on each end, two 10 inches from each end and one in the middle. I used a combination of 1×3 and 1×4 scraps to do this and attached them using wood glue and pocket holes screws. 

SWIPE UP FOR yhe steps