ANIKA'S DIY LIFE
If you have been around here a while, you know I love jewelry! I think they are beautiful art and should be displayed instead of being tucked away in cabinets and drawers.
I made the base out of a 1×10 cut down to a 6″x 12″ board. This can be any size, depending on how much jewelry you need to display.
1
Build the bracelet holder by joining the 5/16″ and 3/4″ dowel. I put the 3/4″ dowel in a vice and drilled a hole with a 5/16″ bit to about half of the thickness.
2
Measure, mark, and drill holes for earrings using a 1/4″ drill bit. The spacing and number are totally up to you.
3
This is where the fun comes in. The sky is the limit with a Cricut machine! You can customize with little notes, quotes, initials, patterns, or even monograms!
4