Renter-Friendly DIY Wood Valance (No-Drill & Fully Removable!)

Build this easy DIY wood window valance in under an hour! This beginner woodworking project creates a custom look to hide dated blinds and is 100% temporary and renter-friendly.

Let’s be honest: we’ve all lived with them. Those generic, slightly yellowed, “builder-grade” plastic mini-blinds. In my case, they were a lovely shade of 80s pink.

I wanted a custom look for my bathroom as part of the rental bathroom makeover, but I didn’t want a permanent project that required heavy drilling or a massive budget. I needed a solution that was stylish, cheap, and, most importantly, 100% temporary.

Enter the DIY Wood Window Valance (also known as a window cornice). This project is perfect for renters or anyone who wants to hide “ugly” blinds without losing their security deposit. It took me less than an hour to build and cost less than $20!

If you would like to see the lovely pink blind that is being covered up in its full glory, here is the before picture :

***This post contains referral or affiliate links. It is a way for this site to earn advertising fees by advertising or linking to certain products and/or services.  Please read my full disclosure here ***

How to Build

Step 1: Measure Your “Ugly” Blinds

Measure the width of your existing blinds. You want your new wood window cornice to sit just outside the brackets.

Pro Tip: Add about 1/2″ to 1″ to your total width measurement so the valance slides on easily without scratching the walls.

Step 2: Make Your Cuts

You will need three main pieces:

1. The Front: The long board that covers the blinds. I used 1×4 boards for these.
2. The Sides (Returns): Two shorter pieces that head back toward the wall. I used 2×2 boards for these so they wouldn’t stick out too far into the room.

Step 3: Assembly

This is the easiest part!

• Lay the 2×2 on the worksurface spaced out per the dimensions you want the valance to be.
• Attach the 1×4 to the front of the 2×2 using wood glue and finish nails. You can also use trim head screws and sountersink them so you can fill the holes later if you like.
• I used a scrap 1×4 board to get 3/4″ spacing between the boards.

Step 4: Apply Finish

• You can fill the nail holes and stain or paint in the color of your choice.

Since this was for my bathroom, I went with a clean white to match the trim and doors. If you’re a renter, this is a great place to add a pop of color that you can take with you when you move!

Step 5: Install the valance

To keep this temporary, I essentially hung it like a picture.

• I attached a D-ring to the back.
• I used picture hanging hooks to hang the valence up. The hooks are each rated for 50Lbs. I am quite sure the wood valence weighs much less than that!

When you have to leave, you can simply remove the hooks which will leave a tiny hole to fill at the end.

It’s amazing how a simple 1×4 and some 2x2s can completely transform a room. No one would ever guess this is a temporary, “no-holes” project!